Question about Maytag Neptune Washing Machines
remove the agitator and watch the agitator shaft to see if it is working properly. This will require a small load setting of water and the machine set to run. If the agitator shaft is working properly
...agitator in place. Remove the nut and pull the agitator off. It may be tough to get it out if its never been removed, over time lots of soap, dirt etc.; gets in there and clogs up the splines. Try ...
washer won't agitate The tub fills with water, but won't agitate in either the wash or rinse cycle. Pump removes the water from both cycles. Spin cycle seems to run normally, but machine cycles down ...
agitator should no rotate in spin cycle maybe a 1/8 turn and no more at the start of spin cycle . If your machine is one of the above machine types maybe you have coins or something under the tumblers
...agitator is the wiring on the motor. There are generally(as far as i know) 4 wires on the motor. It moves back and forth and over time the movement of the agitater part of the motor breaks the wires. ...
Question about Maytag Neptune Washing Machines
...cap and use a hex driver to remove the screw. Tilt out aggitator, and clean back of agitator, hyousing and gear box of the moldy/mildew build up..its kinda gross. That is where the stink comes
Question about Maytag Neptune Washing Machines
...has become stuck underneath and around the agitator. How do I remove the agitator to remove the chord? Thanks sorry to saybut you would probley need to stripp down most of the unit...to remove
Question about Maytag Neptune Washing Machines
...I had the problem before, when a penny was lodged in one of the agitators. I need to know, how to remove the 2 agitators in the washing tub, to remove any debrei You have to pry off the caps on the ...
...remove the center agitator? Or do I need to cut the strap? Thanks so much for your advice. take your hand and feel mid way on the agitator,,theres a little nut remove it..you need 1/4 nutdriver. than ...
...remove agitator? Removing the tub assembly can easially be accomplished but I wouldnt recomend it without having the proper instructions which you can get for your model at ...
1,827 questions posted
Usually answered in minutes!
2,979 Questions
358 Questions
175 Questions
151 Questions