...rinse cycle. Whats wrong? How can I fix it? Take the cover off the back, and look up, next to where you put the soap in, when it's filling/rinsing. There is (like) a (white) plastic valve body, and ...
...to check are at the hose connections and the hoses themselves. If it continues to leak after the water stops coming in , then you have to look at the drain connection and finally at the drum
Question about Maytag Neptune Washing Machines
...stopped on rinse cycle and water was all over floor. please advise I'm not a appliance repair person. I checked hoses and they don't look wet as if there was a leak. check inside ie pump or door ...
...other time. If I manually move the dial to the next stage, the leak stops. How to fix???/ This can be caused by water collecting in the door to tub seal. Best repair would be to replace the door
...water in the drum to wash or rinse the clothes, however it may be the water level is now higher than normal , check for any blockages and check any drain pump filter.If all o.k. it may be the door ...
Question about Maytag Neptune Washing Machines
...rinse cycle, it leaks from underneath i would 1st look to make sure the drain hose is not loose or broken. be sure it is staying in the drain pipe in the wall.it could be a cracked housing on your ...
Water leak from detergent drawer My Maytag Neptune 7500 front loader which is 1.5 years old leaks water from the detergent drawer on the upper left of the washer. The leak happens within seconds of ...
Question about Maytag Neptune Washing Machines
...rinse is when the softener cup is being flushed. Remove the dispenser and clean and inspect the housing to be sure no softener is gumming up the holes and blocking the water flow into the
Question about Maytag Neptune Washing Machines
...WATER IS RELEASED BEFORE RINSE CYCLE AND LEAKS UNDER THE BOTTOM OF WASHER. Possibly because the seal on the pump has been compromised. There may be a blockage( kids sock or smaller item that has been ...
...water valve, the cold and hot hoses and the control board. The hoses have been checked and are hooked up properly to the cold and hot valves. What is left to trouble shoot? Please help. This has been ...
3,973 questions posted
Usually answered in minutes!
1,498 Questions
358 Questions
175 Questions
151 Questions