Question about Maytag Neptune Washing Machines
...open the top of my front load washer (Neptune Mod. MAH3 Need to replace the door locking switch but can't figure out how to open the top of my washer . there 3 screws on the back u take off but to ...
Question about Maytag Neptune Washing Machines
...top cover lip. Open the door then lift the front of the top cover and tilt it toward the rear of the machine. The door locking mechanism can now be removed and replaced.. Reinstall the top cover and ...
Question about Maytag Neptune Washing Machines
...top cover. Open the dispenser cover and remove the four screws securing the dispenser bezel to the top cover then lift the bezel off. Open the washer door and remove the two screws securing the door ...
...open the top of this washer? Is there clips that pop open? NO THERE ARE SCREWS THAT HOLD THE FRONT ON AND HINGES.REMOVE THESE THEN YOU WILL SEE A SCREW ON EACH SIDE FOR THE TOP. DONT LIFT UP UNTILL ...
...Open the dispenser cover and remove the four screws securing the dispenser bezel to the top cover then lift the bezel off to access the emergency access cord. Pull the emergency access cord carefully ...
lid light is on . machine won't start. how to reset lid light 1. Remove top. 2. remove left side lock accuator. 3. open accuator case. 4. Solder small broken wire back to diode. 4. reassemble 5. enjoy
...open heavy load .washing dog bed The Service Manual for reference. Sears Parts Direct for reference. Raise the top of the machine. Insert a flat blade putty knife approximately 2.5? from the left and ...
Question about Maytag Neptune Washing Machines
open a maytag neptune top load washer See the first part of my Clutch repair post that will get to release the washer top from the washer base. Some other handy links; The Service Manual for reference
open unplugging didnt work You can release the washer top from the base with a putty knife See page 33 of the FAV6800A/FAV9800A Service Manual Your machine is a FAV6800A or FAV9800A correct? If so you
Question about Maytag Neptune Washing Machines
top of the unit. Open the dryer door and remove the two phillips screws on either side at the bottom of the door opening,then remove the four screws across the top of the panel it will lean out toward
3,973 questions posted
Usually answered in minutes!
1,498 Questions
358 Questions
175 Questions
151 Questions