Maytag Neptune MAH5500B Front Load Washer "checking fill screens" Questions

...do rate my answer.Thank you. The washer has tried to fill but was unsuccessful. Solution : Make sure the water faucets are open all the way. Check for kinked hoses. Check inlet screens on fill

...fill screens are blocked, It could be a failure of the Cold/Hot water solenoid valves. I would try to fill with hot water if no fill try cold only. It might be easier to go into Service Mode to turn ...

...fill washer with water ,, , chk taps is the water turned on ? check inlet screens on hoses , check wiring connections in harness leading from machine control board to pressure switch,, check water ...

...a nf and stopped working NF means No Fill. Check inlet valve screens at the mix valve where hoses attach to machine. If there is nohumming noise at fill time, you will need to replace the inlet

Code E3 e3 cde show no fill,,,is the water turned on you might have to clean inlet screens,,,check fill vavle ..good luck

...off and remove both hoses from the back of the washer. Check both these hose connections for clogs in the filter screens. If they are clear, then more than likely the fill valve has gone bad. ...

...fill slowly often have a restriction in the incoming water supply -- usually in the screens of the inlet hose washers or the water inlet valve itself. Remove the hoses to inspect this condition. If ...

...fill hoses at the washer. Inside the inlet to the water valve there are inlet screens. Use a thin knife blade or a scribe on the outside of the screens and remove them. Wash them under slowly running ...

...both hoses from the back of the washer. Check both these hose connections for clogs in the filter screens. If they are clear, then more than likely the fill valve has gone bad. I hope this helps

Neptune will not stay running during fill When I turn it on, it starts to fill up, 10-15 seconds into the fill cycle it turns off. If I push the start button again I can get it to start and complete ...