Maytag Atlantis MDE6400AY Electric Dryer "put sliding door back" Questions

...Put it on top of the dryer, insert the control panel tabs into it, and lock them by sliding the control panel to the left. Slide the top panel back and pop it down in the front. Secure the front with ...

...door and pull the front panel off,just tilt the top of panel out,remove the four 5/16 inch screws that hold the front bulkhead on,then remove the top screws and the L bracket on top,remove the front ...

...back panel or do i go in from the bottom? and what am i looking for? thank you The glides are located in the front of the machine. To get to them first open the door and remove the screws on the top ...

...door space, and put it all back together. 2) Cut off the sheet metal extension about 1 inch from the "elbow". Save your cut off piece, and put it back together with a sheet metal sleeve, that you can ...

...the idler wheel back hold tension on it and put the belt around the motor pulley let the idler pulley up till it engages the belt and reverse dissemble don't for get to plug the door switch back ...

...until after the front is back on and then remove the access panel on the back to put the belt back on the motor. You may want to replace the slide plates on the front of the door at this time

...pully. Re-install front dryer cabinet. Make sure to plug in the wires to the door switch and make sure that the drum is re-inserted back over the felt glide on inner cabinet front. Happy to help,

...put front and top back on after deciding if you can feed the belt around motor pulley and spring loaded idler pulley from above or a square door in bacl of dryer. There are a lot of ways the idler ...

...door. Look under drum and see how belt go on pulley so when you go to put it back on you will know how to. Take belt off pulley and drum and pick up on drum and pull it out and there is motor and gas ...

...door facing. how to put new grubber gasket around metal? See the groove on the edge where the gasket fits onto the door? As you peel away the gasket, you'll see how you need to thread the gasket onto ...