Lexmark X2350 All-In-One InkJet Printer "paper size section 1" Questions

paper size for the photos <- use DIN/4 to print on whole page From the Page Layout area, select a page layout. Drag the photos onto the page. Click Printer Settings. Select the paper size and paper

...Paper Size Error but I'm using 8 1/2 x 11 and Standard is the setting when I try to print. Reloaded paper but same error again and again. standard paper size is A4 reset the paper size in the printer ...

...paper size or you can manually select paper tray1 or 2. If you use the Auto Select feature, the application will automatically pull from the appropriate tray based on the document#s paper size. For ...

size paper loaded) and continue to print from tray 2 for the whole job even though letter size paper is required. If the 1st page is letter it prints from tray 1(letter size paper loaded) and does the

...paper size and page setup This section describes the procedure for specifying the paper size or page setup when printing from an application, taking Adobe Reader 6.0 as an example. Note: The screen ...

...copier/printer is stuck on tray 1 size 11x17 but I cannot get it to change to letter size hi. when you open that tray in the front upper section there is a slide where you can select the paper ...

...size of a paper towel tube/core dear friend:1-check the paper and use fresh paper out of wet and stored in dry place.2-use cooling oil and replce oil cartidge in the heater section.3-replace silicone ...

...paper size' is set to 'A4' 4- Click on the Properties button. 5- Click on the Paper / Quality tab, then click on Advanced. 6- In the Paper/ Output section it has Paper size. To the right you have a ...

...size paper" in your printer manual). 10) Turn over the stack of paper in the tray. Also try rotating the paper 180 degrees. 11) Check the characteristics of the media you are using. Use only paper ...

...paper size...right arrow again till u see tray 1...down arrow till you see mpf..right arrow till you see letter. Now that you are in the mfp section you can down arrow and you will see serveral ...