Maytag MER6772 Gemini Electric Kitchen Range "control lock" Questions

...control lock by accident. Here is how to disable it. Hopefully it will work: The Control Lock feature shuts down the control panel pads to avoid unintended use of the oven. The Control Lock feature ...

lock the control panel and both oven doors: Press and release Cancel. Press and hold upper oven Cancel and Cook & Hold for 3 seconds. ?Off? appears in the display and ?Lock? flashes while the controls

control lock preventing the operation of the stove how to unlock the control lock Hi Bruce, this is AP! I understand you are struggling with the lock feature on your Electrolux duel fuel range, model ...

...control lock aid lock does not fully enguage, it keeps cycling This is probably the interlock switch assembly. It tells the control that the door is locked. When it continues to cycle, the control ...

...control will sometimes lock because it "thinks" a clean cycle has been initiated, if replacing the control did not fix the lock icon, test the switch... Incorrect temp probe and thermostat failures ...

...I unlock works fine 5 hrs later it is locked again. What is the problem? The lock mechanism is bad and more than likely the main control is as well, Did this happen after using the self clean

...lock/unlock. Gas/Control Lockout (on some models) Your control will allow you to lock out the surface burners, oven burners and control panel so they cannot be activated. To lock/unlock the controls: ...

...lock button on your control (you may see a picture of a small lock next to a button, hold this button for more than 3 seconds until the control says its locking). If the lock fails then this is your ...

...control and the door lock assembly make sure the door lock mechanism is not jammed. you may need to replace the door lock motor or the electronic control board. . It won't close at all because the ...

...control lock, and if you hold that button down for three to five second it should release the control panel. If that does not help release the panel I would suggest performing a reset and you can do ...