...DLP, it could be the lamp or the color wheel. The flashing lights are a service code. Some TV manuals will describe the code and others require a service manual for the codes. Either manuals can be ...
Question about Samsung HL Televison & Video
...DLP samsung and it wont power on after making a lot of noise (I replaced the lamp) worked fine for a few days now the red light and the right side green light is blinking. any sugge the TV worked ...
Question about Samsung HL Televison & Video
tv and wait a few minutes if the light flashes red or green for a few seconds this is a code that you haveto read eg if 3 flashes then start again it means there is a problem read in between the flash
Question about Samsung HL Televison & Video
DLP television. After operating for a few minutes, the tv shuts off, and all three lights on the front panel flash. After checking the flash code, I checked the sensor (trip switch) on the lamp cover.
Question about Samsung HL Televison & Video
light blinks red; and the unit will not turn on or respond to any commands. These blinks of LEDs are fault indications. If you wish to get more details about these blinking codes, check this link. The
Question about Samsung HL Televison & Video
...DLP and DMD all at once by doing a light engine. Granted, the cost is substantially more, but it might be easier in the long run to swallow $600.00 for a completed set than to swallow $200.00 for a ...
Question about Samsung HL Televison & Video
...light engine from the tv and remove a cover from the lens and a cover from over the colorwheel then two screws that hold the color wheel and two wires. sometimes new codes must be input into the ...
Question about Samsung HL Televison & Video
...light from the lamp. The DMD board is a technician replaceable item and part number varies by model code. Please contact a local servicer to have them look at your TV so they can order the right part ...
...DLP sets) will try 3 times to get the lamp lit before the microprocessor will give up and then the 3 lites on the front will blink indicating a LAMP failure. This process takes about 1 to 2 minutes. ...
Question about Samsung HL Televison & Video
...dlp will turn on with no picture (sound is OK), then will seem to turn off, then back on again without me doing anything. After this ritual being repeated, the lamp and power lights will start to ...
163 questions posted
Usually answered in minutes!
445 Questions
373 Questions
297 Questions
280 Questions
244 Questions