Konica Minolta bizhub 250 All-In-One Laser Printer "document feed misfeed" Questions

...Top feed = Automatic Document Feeder?If YES,please verify misfeed paper beetween coverplaten and feedbelt(Yellow).Is necessary disassembly the ADF.Good luck.You will find a little

Document Feeder (DADF) 061, 062 Scanner, DADF and ROS 007 Paper Supply 008 Paper Feed 009, 089 Xerographics 010, 011 Fuser, Copy Exit 012, 013, 047, 112 Finisher 016, 124, 127 Configuration, Software,

...Document Processor". This message apears when there was a misfeed or something like that. It means that you must put back all the documents, to be scanned again. Clean the paper feed/pickup rollers ...

...misfeed, when there isn't. I don't know if it has to do with the rollers not grabbing the next piece of paper or what. It drives me nuts when I have to scan a huge stack of documents. Do you have any ...

MISFEED IN ADF Most times on these machines the most common problem is worn document rollers. Cleaning them will improve document feeding, most times they have to be replaced espeicailly the lower ***

feed. The document in the link is specifically for your printer. http://h10025.www1.hp.com/ewfrf/wc/documentSubCategory?tmp_rule=2777&tmp_task=solveCategory&lc=en&dlc=en&cc=us&lang

...feed paper, or you receive an "ADF jam" error message: Figure 6. The ADF unit. Check the position of the ADF document guide: Lift up the ADF unit. Locate the document guide on the underside, as shown ...

...document into my computer..I thought I could feed it through the back(like where the paper shoot is)..please tell me there's a better way than doing it one page at a time.. nope..that is problematic, ...

...document, nothing there The paper path arm on the doc feeder popped out of the bracket. You need to remove the two sides of the ADF main feed unit, this allows you to open the unit further. take out ...

Document feeder won't feed. It pulls paper in about an inch or so and says there is a misfeed. We have had someone come out three times and cleaned everything and changed the clutch and a pully-inny ...