Question about Konica Minolta bizhub Office Equipment & Supplies
...imaging units. Each imaging unit has a waste compartment for the residue toner not transferred to the Image Transfer Belt (the waste bottle is for waste from this ITB). The residue toner could be ...
Question about Konica Minolta bizhub Office Equipment & Supplies
...last time the machine was cleaned, Gradation? and Registration? test done. Image units toned up? High end copier likes this needs to be keep up!!!!! As for the imprints replace the FUSER UNIT (HOT ...
Question about Konica Minolta bizhub Office Equipment & Supplies
Model 600. Why is it dropping toner near transfer corona unit? When is the last time the developer and drum where replaced? When the last time was a PM done? Very 250,000 copies a PM must be done? ...
8650 machine error 21 1 Wipe clean the surface of the transfer belt with a soft cloth, if it is dirty. 2 Change the image transfer belt unit if the transfer belt is damaged. 3 Change the PH unit. 4 ...
Question about Konica Minolta bizhub Office Equipment & Supplies
...last week now the prints and copies are so light I can't read them. I have replaced the toner. I would liek to know if this would be caused by the drum or something else? How do I get to the part I ...
Question about Konica Minolta bizhub Office Equipment & Supplies
...last 3 days before i had error c2557, after sometime it was gone, now my printer showing c2551, i don't know what i do, give me your valuable reply. C 2557,C 2558 Black TCR sensor. C ...
Question about Konica Minolta bizhub Office Equipment & Supplies
Konica minolta bizhub 164 have Trouble service code c2558 Code: C2558 Description: Abnormally high T/C ratio - The T/C ratios detected by the TCR sensor board (TCRSB) are above the threshold for the ...
Question about Konica Minolta bizhub Office Equipment & Supplies
...Imaging units for Minolta Bizhub and CF series.http://www.chipreset.eu You need to replace the drum and developer, then reset the drum and developer counters and f-8 the developer this is all done in ...
...imaging unit. Last solution turn ON the copier open the front door ,enter in service mode,select sistem1 or 2 ,select IuU Unit,select Unit K ,select new release press start and after job is completed ...
MINOLTA EP1030 IS NOT GIVING AN IMAGE Check the assy. below the image unit. Open the machine pull out the image unit below it on the machine you see a black plastic assy. with machine off press it ...
305 questions posted
Usually answered in minutes!
1,023 Questions
924 Questions
417 Questions
256 Questions
111 Questions