Question about Konica Minolta bizhub Office Equipment & Supplies
...TRANSFER UNIT LOCATED ON KONICA WHERE IS THE TRANSFER UNIT LOCATED ON A KONICA MINOLTA BIZHUB C250 HOW DO YOU REPLACE IT WITH A NEW ONE? Unit is in the right side cover. New one should have ...
Question about Konica Minolta bizhub Office Equipment & Supplies
...transfer unit and fusing unit?? Is there a chip reset that I can buy for the transfer unit and fusing unit? I just purchsed the resets for the image units and they worked great. I don't know exactly ...
Question about Konica Minolta bizhub Office Equipment & Supplies
transfer unit and clean on vacuum cleaner the transfer belt cleaning blade.If you see the stripes on transfer belt after cleaning is work normally.If not observ stripes on transfer belt the problem is
...Transfer Belt/Cleaning Unit. SOLUTION: Perform an I/O check on M11 then verify that the motor and Transfer Belt/Cleaning Unit drive components are not bound up. Replace M11 (p/n 9314 1100 ...
Question about Konica Minolta bizhub Office Equipment & Supplies
...transfer unit. How to solve it, or at least what this error code means? hi, from the service manual: C2451: Item: Transfer Cleaner Unit New Article Release Description: A new installation is not ...
Question about Konica Minolta bizhub Office Equipment & Supplies
transfer unit on bizhub C250 how to replace the transfer unit its not so hard, open side door, remove 2 screws, and pull out the transfer unit gently. and reinstall new TBU. BE VERY CAREFUL WITH NEW ...
...the transfer belt unit contact and that of high voltage board for connection and clean or correct the contact. Change the image transfer belt unit. Clean the sensor windows on the transfer belt
...Unit (Image Transfer Belt Unit) is installed.When a new transfer belt unit is installed in a machine an internal component on the transfer belt unit changes state; this now indicates that the ...
Question about Konica Minolta bizhub Office Equipment & Supplies
...unit (image transfer belt unit) is installed. Remedy 1 Reinstall unit. 2 Check there is a short circuit in the fuse of the transfer belt unit. 3 Check the PRCB connector for proper connection and ...
...transfer unit Open the side door by pressing its lever outward.At left and right sides of transfer belt you will see screws.Two screws, one at left side and one at right side.open the screws and pull ...
1,254 questions posted
Usually answered in minutes!
924 Questions
417 Questions
261 Questions
256 Questions
111 Questions