Dacor Millennia MOV130 Electric Single Oven "door problems" Questions

...problems: * A problem with the door hinges * Broken oven door springs * A problem with the gasket inside the edge of the oven door This article from the San Francisco Examiner newspaper describes the ...

...door problems. After the oven heats up, the Close Door light comes on and my oven stops heating. Even though pressing in the door latches did not change the status, I replaced the door latch with a ...

both oven doors do not close properly. lights stay on & can't heat properly with doors not closing tight. is there an adjustment for these doors? We have similar Jen Air double oven and with the ...

oven light stays on lower oven light stays on. How to fix it? try cleaning the door sensors there is a door light switch on oven side, like the one on the refrigerator,so when you open or close the ...

Door The door on this oven will not stay closed all the way. I have taken the door off and put it back on, but no help. The light will not turn off because of this problem. Please help your oven needs

The oven door does not completely close and travels too far in the open position . It stops about 1 inch short of completely closing which leaves the oven light on all the time. A service company ...

Self Cleaning problem I start the bottom for self cleaning and after showing that the door is locked appear in the screen F9 . Door is locked and is not opening I disconnected from the power supply ...

euro maid sc1531 oven door dose not close at the top oven door dose not close at the top when door is closed there is a gap at the top of the door Did you solve your problem???? Cause I am having the ...

Stoves 900GDO Bottom oven door seal Door does not close to the seal at the top thus allowing a great deal of heat to escape You will probably have to replace the oven door hinges. This should solve ...

Jenn-Air model JES9750AAW. Oven door squeaks, especially when oven heated. Have tried to lubricate hinges with high quality turbine oil, teflon wheel bearing grease, powdered graphite, and WD-40. Not ...