Question about Frigidaire Washing Machines
...Affinity washer door won't open after wash cycle The door light keeps flashing and the door stays locked. I've tried re-running the cycle and unplugging it in theopes that it will reset. No luck ...
Question about Frigidaire Washing Machines
...Affinity washer has black mold on the rubber seal .how do I remove it . it takes 5 cups bleach put some in detergent cup the rest inside the washer run full cycle then fill wash at least 1 more time ...
...affinity washer and dryer. The last loand did not complete its cycle. It is partially full of water, but not enough to seap out. Itmakes a buzzing sound and will not spin. It is not the type of buzz ...
running the full 45 minutes. My dryer is displaying E68 in the manual it says AD is the adjusting time according to moisture level for those who keep drying but display this it is normal for those who
Question about Frigidaire Washing Machines
...running a full cycle and removing the clothes, water continues to fill the tub. If I run a Spin Only cycle, it takes the water out, however, fills up again. It doesn't matter if the door is ...
Question about Frigidaire Washing Machines
full speed if they are overloaded, try it with less clothes. Sounds crazy but try a running the load a few times with NO soap. These washers stop going to a high spin if they detect that too much soap
Question about Frigidaire Washing Machines
affinity front load washer will not complete the spin cycle I have sopping wet laundry. The washer washes AND DOES DRAIN but it will not do the spin cycle. The washer works through a normal wash cycle
Question about Frigidaire Washing Machines
my washer spins but doesnt spin on the final spin and leaves the clothes all soaked. it stops at 6 minutes on the final spin is the machine draining correctly? the machine will oftin stop if not doing
The washer shuts down in the middle of the cycle.clothes are full of water. I put it on spin cycle to get rid of the water. It seems to happen with only two or three towels in a load.new motor needed.
Affinity 6000 & found unit would not spin. Found the door safety switch contact spacing that was supposed to close when the wax motor heated up was too wide and the travel of the wax motor plunger
3,279 questions posted
Usually answered in minutes!
1,146 Questions
974 Questions
650 Questions
256 Questions
168 Questions