...cover is found the compressor relay (labeled "A" below), overload protector (labeled "B") and the electrical terminals of the compressor motor. Remove the compressor relay by pulling it straight off ...
...wiring is simple //remove compressor cover to view relay ...remove it with screwdriver ..dont worry about breaking this relay .remove it to see 3 terminals ..one is start /one is run /one is common ...
...cover on side of compressor, no relay seems to be plugged into compressor - only 2 wires blue and brown which then run behind rear panel up to control board. Plastic cover also has 2 white wires ...
...Remove the cover. May look hard but it's simple. There will be three connections under the cover and 2 will go through the start relay. Unplug them leaving the three prongs exposed. They may be ...
Question about Maytag Refrigerators
...Remove the cover. Inspect for burned wires. Take note of the relay components. Remove them and lay them out in the order and orientation in which they were removed. If you see burn marks on the you ...
wiring diagram. Hello Thayden, I understand that the Refrigerator compressor is not working on your unit. There are three possibilities of why the compressor is not working, the compressor is bad, the
cover is found the compressor relay , overload protector and the electrical terminals of the compressor motor. Remove the compressor relay by pulling it straight off from the compressor. Pull the wire
cover. Remove wires from the compressor terminals noting where each one goes. Remove "Overload" (round black disc) from the line cord (other end of overload was connected to compressor. The other side
...remove the electrical cover on the compressor to see if any wires are burnt off.you may have a defective start relay,wire off or compressor seized,that age not cost wise to replace compressor Take ...
...Remove retaining clip on wiring side of compressor plastic cover. NOTE wiring connections to terminals on the OLD relay. 1, 2 4 4 ect... make a simple wite color to terminal number sketch. PULL off ...
51 questions posted
Usually answered in minutes!
1,894 Questions
803 Questions
611 Questions
487 Questions
348 Questions