Maytag Ensignia 3.3 cu. ft. Top Load Washer "repair water level knob" Questions

...water level, test, adjust, test adjust ~1/2chance of fixing it If fail replace level selector body Yes its not hard to replace this switch.If you can remove the panel the switch is on while unplugged ...

...small hose on water level switch is secure ..does water shut off when timer knob is pushed in?if not suspect fill valve stuck open if it does shut off suspect water level switch no repair just ...

water sensor location? Thanks so much, this is my first try at home repair! Hugs, carole Yes, Kenmore is uniformly easy to work on, everything comes off from the front. There are two 80 models, on the

...level sensor body The water level switch body contains a small spring that is not really up to the job and stretches over years, do this repair, on call, no parts, takes 15 minutes,, 3-4 times a ...

...stretches over years. Its a common occurrence, and I make this repair, on callouts, no parts required, couple times a month you may have to flip the switch to reset to get the water to restart ...

...water level which can be interupted by pushing in the timer knob. Lid switch does have an audible 'click'. This is probably a bad timer motor. Two screws on right/left of head, flip head back. You ...

...water level broke off. I think I need to replace the entire switch. Is this something I can do myself? Yes you can do it. For now just turn it with a plier until you buy a new knob or get one from ...

...water, but clothes do not all even get wet????? How can I correct the problem? I have this problem too.  Called the repair man out to the house & he just told me it was set at the factory ...

...repair A plastic hose couples from a bottom outlet in the outer tub up to the back of the water level control and increasing air pressure, exerted by the rising water level in the tub, causes the ...

...water level. If no water check house shut off valves, or check in control panel where you just fixed the knobs and see if you accidentally unplugged wires to the plastic inlet valve which is the part ...