Question about Solis Coffee Makers & Espresso Machines
...hopper out. Remove the outer burr with the wing-lets. Can go back in either way. Clean with air or vacuum out grounds. Use small brush to help clean grounds. Reinstall burr. Line up notches of the ...
Question about Solis Coffee Makers & Espresso Machines
...upside down. Rotate the bean hopper to loosen any grounds that might be holding the burr holder. Now remove the bean hopper and try again to remove the holder. Only the outer burr comes off, this
Question about Cuisinart Coffee Makers & Espresso Machines
...beans. 3. The bean hopper, bean hopper lid, grind chamber, and grind chamber lid can be washed by hand with hot, soapy water or placed in the top shelf of a dishwasher. Dry thoroughly. a. Remove the ...
Question about Solis Coffee Makers & Espresso Machines
Remove the beans and ground hopper. Turn the machine upside down and then gently rotate the bean hopper back and forth until it will rotate completely (270 degrees). This will shake out any grounds in
Question about Solis Coffee Makers & Espresso Machines
...remove the beans from the hopper. Remove the hopper. Remove the burr. Turn the grinder upside down over the trash can. Put the burr back in only make sure that the burr is down. Install the bean ...
Question about Solis Coffee Makers & Espresso Machines
beans seem to have clogged our coffee grinder up. What can we do? Rotate the bean hopper counter clockwise until it stops. Lift it off. Remove the outer burr with the 2 wings and clean under the burr.
...remove the outer burr. Twist the bean hopper counterclockwise until it stops. Lift the bean hopper out. There is a cream colored ring with 2 tabs that will lift out holding the outer burr. To get the ...
remove the bean hopper and grounds drawer. With pliers pull the timer switch off (straight out) Next turn the machine upside down Now take a straight blade screw driver (1/4") Insert it in the slot on
...Remove bean hopper, clear chamber of all beans, either by grinding or using a vac cleaner, then turn adjustment collar finer until it cannot move, then back it up about 1/4 to 1/2 a turn. That should ...
remove it. Then a tooth brush. When reassembling the burr assembly turn all the way in until you see the acorn nut in the center rotate. STOP. Back the assembly back until the nut stops rotating. That
11 questions posted
Usually answered in minutes!
119 Questions
106 Questions
56 Questions
40 Questions
36 Questions