MTX (SLH-T7512X2-A) Car Speaker "subs 4ohm" Questions

...subs are 1500 peak(each) and the amp is 3000w mono If you have a DVC 4ohm speaker, and you are using both voice coils, the amp is seeing a 2ohm load. If you bridge the amp, you CAN run both subs as ...

...- on the amp. NOTE IF YOUR AMP IS BRIGED THIS IS A 1 OHM LOAD!! IF THE TOO SUBS ARE ON ONE CHANNEL THIS IS A Two OHM LOAD IF YOU ARE RUNNING 8 OHM SUBS THEN YOUR AT 4OHM PER CHANNEL AND 2 OHM ...

subs are dvc 4ohm & the amp is 4ohm 2ohm & can be bridged to 1 channel.. Use good quality wires-- the cost is the factor for high connectivity with low resistance- You can bridge the two sub's

mono amp to a 4ohm dvc sub i have a sony XM-1S amp and a cerwin vega 4ohm dvc 15" sub. can i wire them together to get a 2ohm load Hello joverstre525, Sure, just wire both voice coils in parallel to ...

Coustic Car Audio 12RS Car Speaker Watts I have a 12" Coustic Car Audio 12RS Car Speaker/Subwoofer which has a 4 ohm single voice coil, and I would like to know the maximum watts that it can withstand

...4Ohm = Max RMS of your subs. You should run the max of your subs, less wear on the amp you are using , and i doubt you will ever need to turn it up far before it blows out your trunk or window :P ...

4ohm 12" subs? I have a 2 channel amp, with two outputs on the back of the sub box. I ran my wires correctly from the back of the sub box to the amp, but only one sub was firing. What is going on

can i run a 4ohm.dvc & a 3ohm.svc off of a mtx te 801d Th4ohm.dvc is a image dynamics 1000 rms. &the 3ohm. Is a jl w7 svc. if you wire the 4 ohm sub voice coils in parallel you will have a 2 ...

...subs are 4ohm each.Then wire the subs in series then wire them to amp in bridged mode..caution do not wire subs in parallel if they are 4ohm .This would bring impedance to about 2 ohms and would be ...

...subs and 1 Cyclone 2000watt amp specs are 2x1000 wattsmax@4ohm -2x1500watts max@2ohm -1x3000watts max bridged@4ohm how do you suggest to wire them up? The best you can do is connect the dual 2 ohm ...