iRobot 5900 Scooba Robotic Wet/Dry Vacuum "troubleshooting priming water pump" Questions

...water in solution tank). When you start the vacuum up, the pump starts to prime itself. If you have air in the system, it takes a little longer to prime. Allow the vacuum to run for 1 minute before ...

...water and detergent tanks being full, there may be a bubble of air stuck in the pump or the hose. To fix this, you need to turn the cleaner on and lower the hose down to the floor. Next, prime the ...

...water to floor or hand dispenser on my bissell power pro steam cleaner That means that the pump belt is worn or stretched and needs to be replaced. Here is a link to the belt you need and the manual ...

...water pump made sure nothing is cloged up made sure both the soap and bladder are full so it primes made sure the little valve the trigger goes to is working .I have made sure there are no clogged ...

...priming the pump with water. The iRobot website shows how to do this under the Scooba troubleshooting section. Then run the unit with water and vinegar (in place of the Clorox Cleaning Solution) if ...

...troubleshooting tips that you can do to try and fix the machine: Step 1. Fill the clean water solution tank with water, and remove it from the machine. With the tank removed, press the piston at the ...

...water and cleaning solutions are full. Nothing is going through the flow assembly. The selection switch is in the correct position Hi, I checked through the troubleshooting for this model and came up ...

...troubleshooting. - Check for debris on spray tips. Clean them with a soft brush (on old tooth brush works well). The spray tips may be lifted out for easier access. - Ensure the tank lid is properly ...

...water and air through the reservoir and could hear it spinning. I still had all of the covers off, turned it on and got a steady stream of spray for a minute, put it all back together and it is doing ...

...priming steps, it is OK. Any help would be appreciated. Thanks. Please check the following with liquid in both tanks. - Check to see if the machine will spray through the hose with the setting on ...