Brother HL-5240 Laser Printer "paper port page 2" Questions

Paper LEDs are lit. Release the GO button. All LEDs will be off. Press the GO button 8 times. The Ready LED will flash briefly while the printer is reset. After the printer is reset the Ready LED will

...port print the network page if it is smaller than the page change paper selction pcb located behind the logic pack. if the the line at the bottom of the read out is missing and the box is incomplete ...

...paper through, but when it prints the copy, it only prints a blank page. There are only 2 wires that need to be connected and the ends are different sizes so it's hard to not connect it right. Any ...

paper tray completely and look inside the open port toward the back and in the center from left to right. A flashlight will help. You should be able to see a gray/black rubber tire an inch or inch and

...paper. this is your data cable problem change datacable and change setting to your computer cmos setup go cmos setup find parralal port mode option select EPP+ECP First you change your datacable if ...

...port on the PC. Hi Don't worry Turn off the Computer and the printer . Checked the usb connection from the Printer to Computer connect it to different usb slot Remove all the Papers from the Printer ...

...paper wasting irritant? Could have a corrupt driver. Disconnect the printer or at least be sure it is turned off. I'd do both and when the CD software program asks you to connect the printer to the ...

...port and stating paper jam Try the Following Steps 1. Turn On the All-in-one unit 2. Disconnect the USB cable from the unit 3. Press and Hold OK and Cancel button on the unit while plugging in the ...

...paper cassettes, it reverted back to the 4 lights and no print on the page. I have turned it and the computer on and off several times; and run through the trouble shooting system. I tried ...

...Paper size that you are using >> Click on Apply and then on OK. Try Printing, that should resolve the issue that you are experiencing with. If the issue still persists, try installing alternate ...