Hotpoint Ultima WF860 Front Load Washer "mean pressure starts stops" Questions

Ad

Question about Crosley Washing Machines

1 Answer

...pressure switch or the inlet valve. To figure out which when the cycle starts and the water is pouring in pull the power cord. if the water stops it means you have a bad pressure switch. If the water ...

Ad

Question about Kenmore Washing Machines

1 Answer

it starts to fill,stops starts again to fill, stops and gives an f4 error code Hi. F4 means that there is a problem with the pressure switch. Here an article explaining how to diagnose F4 problem.

Ad

Question about Haier Washing Machines

1 Answer

...starts to over flows check the small tube from the bowl up to the water level sensor check the water sensor is operational check /replace the water control solenoid valve it works like this as the ...

Question about Daewoo Washing Machines

8 Answers

...stops and says e 8 preshar svech problam Pressure switch error which means pressure switch may be bad or board is bad or wiring between the 2. Also could be hope in pressure tubing from switch to ...

Question about Whirlpool Washing Machines

1 Answer

...Washer stopped and flashed LF and now won't start. Any ideas what is wrong? Hi Error code LF means long fill. This means that analog water level pressure sensor signal is out of range or the ...

...stops it means the pressure switch is bad. The pressure switch can be located inside the control panel. It has 2 wires and a plastic tube sticking into it and is attached to the water level knob. If ...

Question about Hotpoint Washing Machines

1 Answer

...mean? Hi, The F1 fault code on this washer indicates that the water level pressure transducer signal is out of range. The pressure transducer air hose tubing being pinched or crimped can cause this. ...

Question about Washing Machines

1 Answer

...pressure to make the switch stopping the water from filling and allowing the wash cycle to start. . This tube can get clogged and the switch won't work. Remove the tube and clean it out. Blowing on ...

Question about Haier Washing Machines

1 Answer

...mean? Error E11 means either: The water level can not reach the reset water level within 5 minutes OR The water level can not reach the setting water level within 8 minutes What this means is check ...

Question about Hotpoint Washing Machines

1 Answer

...starts to beep. I just did wash yesterday and haven't tampered with water levels, so can't quite figure it out. FH means that the machine hasn't detected enough water entering the machine or possibly ...

Not finding what you are looking for?
Hotpoint Ultima WF860 Front Load Washer Logo

1,290 questions posted

Ask a Question

Usually answered in minutes!

Top Hotpoint Washing Machines Experts

vince

Level 3 Expert

1234 Answers

gbob59

Level 3 Expert

3042 Answers

James Hehling
James Hehling

Level 1 Expert

11 Answers

Are you a Hotpoint Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...