position of the old belt, and slip the new belt in place. Keep the grooved side of the belt down. 11-- Push the idler pulley toward the motor and loop the doubled-up belt around the idler pulley. Slip
Question about Washing Machines
...position. And you or someone else presses the door engagement switch in. If it starts up then u have bad windings Another thing to check is the belt safety switch. With a multi meter. Especially if u ...
...proper setting (eg. RINSE). Be very careful as the moving parts could cause injury while the front panel of the washer is removed and the tub is turning. Step 2: Watch to see if the belt is still ...
...belt tensioner can then be unloaded then you can remove the drum throught the front. You will then have the gas valve exposed to be able to change. Hope this helps someone. I took the time to type ...
...belt from the manufacturer. (Some washing machine belts are designed with special characteristics not found in automotive belts.) * The clutch may be worn. If your washer is a GE, it may use a clutch ...
Question about Washing Machines
...proper connection, or, less likely, it could be a broken wire. With an ohmeter, one can check the connections. My washer has a schematic taped inside the top sheet metal, but if you don't see one, ...
Question about Hotpoint Washing Machines
...belt is broken or worn, replace it as well. - Check the MCU. Connector 1 is the Serial Communications Link between the MCU and CCU. Connector 2 is the connector to the drive motor. Resistance checks ...
...proper spin speed, the clothes may be too wet at the end of a cycle. Check to be sure the load is properly balanced and run a spin cycle again. If the clothes are still wet, you may have a worn or ...
...belt is broken or worn, replace it as well. - Check the MCU. Connector 1 is the Serial Communications Link between the MCU and CCU. Connector 2 is the connector to the drive motor. Resistance checks ...
position). 9. Carefully align and reinsert the upper portion of the agitator to the lower portion. Again, making sure the two pieces align correctly. 10. Place the entire agitator assembly back on the
589 questions posted
Usually answered in minutes!
886 Questions
666 Questions
541 Questions
500 Questions
151 Questions