2001 Hyundai Elantra GLS "pcm 2 manual" Questions

...2 not scanning the PCM to see the error DTC and share it. no engine or country told nor what transmission is there and if car has ABS or auto or stick shifted manual transmission. sorry cars are not ...

...if the NOID lamp tests is off , on #2 key on, then the PCM is ok. the acid test is unplug

...PCM. Car goes into gear but feels very sluggish like the brakes are dragging, but it will roll easily (starts out in 4th gear), you manually shift to 2 to get it moving, once it's moving you put it ...

...pcm 2 wire work fine flash when cranking cut the db/dg wire at the pcm it has a constant ground on it . what would cause the pcm to be grounded at all time on this wire ? I had got its manual from ...

...PCM FIRST.
AND FUSE GOOD.
Code DTC P0500????
some cars us 2 speed sensor 1 and backup.
the scans report them all every one that fails.
make sure ABS is happy too.
i will read your ...

2: scan the PCM for A/C errors. (posted now over 1000 times) 3: run the AZC if opted day 1, self test, and the 50 errors possible there. chapter 24. click WJ jeep, here, read chapter 24 then 8w wiring

2 Sensor 1 P0300--Random Multiple Cylinder Misfire I would suspect that the camshaft position sensor is bad. This is a quote from the tech manual: The Powertrain Control Module (PCM) uses the camshaft

...PCM to put it in limp-home mode. Car goes into gear but feels very sluggish like the brakes are dragging, but it will roll easily (starts out in 4th gear), you manually shift to 2 to get it moving, ...

...2 and the solenoid clicks. I also installed an igition relay as this was a common problem in its time. I am begining to think the pcm is at fault. I can manually shift all gears but automatically it ...

...PCM uses 2 filters for the fuel level percent. The slow filter is used during normal operation. The fast filter is used when the engine is just started or when the vehicle is in Park or Neutral. The ...