...hot line to the motor run a pair of wires from the batterie 1 pos 1 neg speaker wire will do unplug the window motor and run it direct pos on 1 wire neg on the other flip the wires to change motor ...
power. If one wire is always hot and the switch is centered, the motor may be fried. You can try applying fused power from the battery to one wire and grounding the other to see if the motor will move
...HOT when the wire touches ground, and go back to COLD when the wire is removed from ground. If it works as it should, you need a new sensor. If the gauge does not respond as outlined, the gauge or ...
large and small red wires go to battery hot all the time and the white wire will go to ignition hot. (note): if car wont shut off after running you will need to install a 30amp diode on the white wire
Question about Ford Cars & Trucks
...hot did the engine get in degrees F? If this wiring is correct, the two fans use the same voltage and ground, they can't run independently unless one fan is faulty or wiring problem at the splices. ...
...hot wire. 1 hot wire when you turn on the switch. 1 ground, and the other wire goes to the pump. Test the ground to be sure it is good. If so then jump a hot to the one that goes to the pump and see ...
...wire Hot in start from CJB Fuse #20 is pin 3, Red w/ black stripe wire Hot in Accessory or run from CJB Fuse #8 is pin 10, Black w/ Pink stripe wire. Grounds in the connector : pin 2, black pin 11 ...
...then the pump would run continuously. You can repeat the above having an assistant hold the switch, one wire should light the light in both the steps. Step one finds the HOT wire, step 2 the
hot wire. You can check it real fast: check for voltage on any injector connector on bank 1, with the key in ON. The inj. connector only has two wires, a power and a ground wire. One of them should be
15 questions posted
Usually answered in minutes!
1,503 Questions
1,180 Questions
1,131 Questions
1,254 Questions
1,082 Questions