Question about Measuring Tools & Sensors
reset to synchronize with the remote sensor. You would need to take the batteries out of both the remote sensor and the base station and then re-install all the batteries in both units (or three units
Question about Oregon Scientific Measuring Tools & Sensors
...reset button re-inserting batteries in main unit and pressing reset button. i think the trick is to ensure that the batteries go in the remote unit first, then the main unit after that. It has taken ...
...reset hole. No change. Push and hold down the channel button, wait for beep, then on the sensor, push and hold the tx button, wait for beep. I had tried everything I could figure out, how to get the ...
Question about Oregon Scientific Measuring Tools & Sensors
change battery on remote sensor. Still doesn't work. I think I have to reset it but can't remember how. Both the remote and base units have a very small hole near the battery spot, less than 1
Question about Springfield Measuring Tools & Sensors
instructions for springfield precise temp model 91455 CHANGED BATTERIES AND NEED TO RESET TIME AND OUTDOOR I also reset my 91455 today. Go online to Springfield precise temp manual 91455
Question about Oregon Scientific Measuring Tools & Sensors
...reset button on the main unit first, but that may not be your problem. Double check the batteries to make sure they are installed correctly. If one of the batteries in the outdoor sending unit is in ...
Question about La Crosse Technology Measuring Tools & Sensors
...outside temperature even though I changed the battery on both the inside and outside unit Find reset pin hole on base unit. Push in with a paper clip. Pin hole may be in battery
Question about Measuring Tools & Sensors
batteries and pressed reset. There was rain water inside the device, clearly not weather proof. Not good for an outdoor device!! take the batteries out take the back off dry it with a blow dyer on low
Question about Oregon Scientific Measuring Tools & Sensors
reset button and change the channels on the remote sensor before I finally remember that you need to do the following to get the sensor to talk to the RAR186 base unit: On the base unit (RAR186), hold
4 questions posted
Usually answered in minutes!