...voltage. It is better to have 125 -127 VAC under a no load condition as the more electrical load you add the more voltage drop you will notice. It is best to adjust the generator to 122.5 -123 VAC ...
...UNDER FLYWHEEL. ONE LOOKS LIKE ARMATURE THAT POSSIBLY SUPPLIES PRIMARY CURRENT TO THE HIGH VOLTAGE COIL--- TO SPARKPLUG. THE ARMATURE COIL HAS 4 WIRES LEADING TO THE GENERATOR. PLEASE EXPLAIN THE ...
...voltage you need to lower the speed of the generator engine. To do this there should be a screw on top of the engine under the tank when your facing the recoil. This screw presses on a arm that ...
Question about Generac Electrical Supplies
...under heavy load for prolonged time, and one / both of the diodes in voltage regulator have opened up. You will have to disassemble the end housing of the alternator to get to these, and then test ...
Question about Briggs & Stratton Electrical Supplies
...you also will use less amps. to run anything at a higher voltage... this places less stress on the generator... I would not mess with it...when it is fully loaded you will be down under 120v ...
Question about Coleman Electrical Supplies
...voltage regulator in coleman generators (generator is actually made by generac) and is 100% dependent on engine speed. There is a screw under the tank when your looking in from the recoil side. It ...
under load, voltage drops but engine speed doesn't increase. Again, if I increase engine speed by hand, voltage will rise. Most generators use a flyball type governor within the engine to control rpm;
Question about Watts Electrical Supplies
...fuse it's fine? In what position is the switch under the voltmeter and does it read some voltage, may be very low? Is the main switch in run position? Is there a charged battery connected to
...rotor, wiring etc. MOST common is shutting the generator down under load and NO NO. The AVR goes wide open to try and maintain voltage on a gen that is stopping, always disconnect loads then shut ...
...UNDER VOLTAGE AND LOW BATTERY VOLTAGE Under voltage would be low output voltage from the generator power head. Verify that the motor is funning at full speed to check the output voltage. Low battery ...
7 questions posted
Usually answered in minutes!
58 Questions