Generac Inverter Ix2000 Gas Portable Generator......new "protect check voltage" Questions

...voltage but never heard of one over loading. I've always kept it serviced and protected from inclimate weather. the governor is not set properly, good job catching this issue. also check it under a ...

...voltage with a load on & some protection. Work safe fri st check your tag on the gen set. should read 3600 rpms at 60 hz. set your rpms so you see 120 volt no load. (this should be at your 120 ...

check the voltage coming out the plugs but i get no readings When you have a generator with a inverter in it you have to be careful of overloads an static electricity. More than likely one or more otf

...protect the generator and any connected electric devices. The AC pilot light (green) will go off and the overload indicator light (red) will stay on, but the engine will not stop running. When the ...

...voltage regulator setpoint for more than 1 second. This protective becomes active 30 seconds after engine start could be a wiring fault also be sure to have a large enough supply line The same thing ...

...check the charging circuit. This OFTEN involves a rectifier module which is usually about 1 inch square with four leads. OFTEN there is a fuse, sometimes within the generator housing (stupid place) ...

...voltage reading from it. Many auto parts stores sell and loan battery load / meters expressly for this purpose.  They look like this:If you have a battery that won't stand up under load, you ...

check on both the generator head and the engine if it has HIGH HOURS of runtime. Namely the the BRUSHES on the generator head as I also don't know what normal LOAD you are putting on your Genset there

check the pulsating condition by stabilizing the governor linkage with your finger and see if the pulsating stops. That points to a bad spring. It can be a problem of the wind vane ? of the govenor or