Dell PowerEdge 2600 Server "turn raid" Questions

Did you experience a power event? Go to BIOS (F2), and make sure that RAID is Enabled. If RAID got turned off (power event, BIOS reset), then it will give you that message. If RAID is already enabled

...turn the machine off before you can pull that drive out. Also: Hot-plug drive installation is not supported for systems without an integrated RAID controller or host adapter expansion card! Look for ...

...raid 5 to Win 7 and turn it into a JBOD. I can't get it to recognize the dvd player so the win disc won't fire up...ideas? Thanks! Is there a RAID card Eg PERC installed? If so, did you use the ...

RAID cage and replace the drives. Turn the unit on and listen to the drive(s). Are they spinning? Are they making a clanking sound? (bad) if both are bad you will have to replace them and restore from

...of one hard drive the exact same thing is on the others. Drives 1 & 4 show failure. When turning it the server won't boot up and shows "No Boot Device Available." If Drives 2 and 3 are ...

...until you turn the scsi controler assuming you are using the integrated card.If you still cant the on board raid controler uses a raid dim if you can change thi note it must be the same type. Good ...

...Turn off remove all 3 power supplies clean, replace 2: Clean the insides removes and reset each add-on card? 3: Remove each of the SCSCI drive from the front ?DONOT MIX? up makes sure each drive ...

...won't do a good job at cleaning both (or more) drives. Check your BIOS to make sure the Raid is turned on. Then run a good Raid anti-virus

...it set up with Hot Plug drives? If so replacing the drive with a new one will start the RAID rebuild. Otherwise one way to turn off the bleep is to reboot and go into the RAID controller ...

...go away. I have restarted the server, but it eventually comes back. I have also unplugged and turned off the battery backup as that was thought to be the initial source. It is the alarm for