Question about Dell PowerEdge Computers & Internet
RAID battery that is indicating failure. Either way, this is probably an LSI RAID controller. Even after you correct the issue, you may still have to use the RAID utility (megacli in Linux) to silence
Question about Dell PowerEdge Computers & Internet
...codes indicating Processor, CPU, Memory or Systemboard failures, Dell PERC (PowerEdge Expandable Raid Controller) or SAS Controllers (Serial Attached SCSI) generate beeps to alert failures on the ...
...failure indicators. They are using RAID. What do I need to do? Go into the RAID setup during bootup (not always in the BIOS), but will post somewhere on startup (should say SCSI/SAS Controller card ...
Question about Dell PowerEdge Computers & Internet
...Chances are that either you had a drive failure or the metadata on your RAID volume (JBOD?) was corrupted. This is a common issue with these LSI-based PERC[5-6]i RAID controllers that Dell
failure. Which indicators or POST/BIOS/RAID BIOS reported you the errors? Was it from the OpenManageSA? Please specify the Hardware Controller model and manufacturer with the version (RAID controller)
Question about Dell PowerEdge Computers & Internet
...failure. i remove the disk and put it back on but i still have the same problem Hello, You may have a damaged hard drive and it needs to be replaced. If the system is still under warranty, Dell will ...
Question about Dell PowerEdge Computers & Internet
...RAID systems fail if you lose more than one drive, so I'd replace that drive ASAP. The beep tone(should be continous) you are refering to is that of a failed drive Usually the perc card will emmit a ...
Question about Dell PowerEdge Computers & Internet
...raid 5 The obvious is to repair it, but if you have another identical server you can place drives and access data. The replacement should boot as failed server. Make sure to track drives and slot ...
Question about Dell PowerEdge Computers & Internet
...Raid.... Unknown Error Hello Dear, I am using Dell Power Edger 1800 with Linux AS-3 ... i am copying here my error log messages here... Could you please help me to resolve this error... 3 Monhts ago; ...
...or F2 to setup" Please why? Did you experience a power event? Go to BIOS (F2), and make sure that RAID is Enabled. If RAID got turned off (power event, BIOS reset), then it will give you that ...
114 questions posted
Usually answered in minutes!
139 Questions
105 Questions
37 Questions
27 Questions
25 Questions