Konica Minolta Bizhub Press C6000 Copier "controller turn" Questions

...Controller. 2)Turn on the copier and short the jumper wires JP3 and JP4 on the dc controller pcb with a screwdriver. 3)The count ratio indicator on the control panel turns on 'F'. When 'F' is turned ...

...controller memory error Action Turn off the power by using the power switch, wait at least 30 seconds, and then turn on the power and wait for the printer to initialize. If a surge protector is used, ...

...Controller. Turn on the copier and short the jumper wires JP3 and JP4 on the dc controller pcb with a screwdriver. The count ratio indicator on the control panel turns on 'F'. When 'F' is turned on ...

...not connected Check the cable connections between the printer and controller. Restart the printer. If that does not work then turn the printer off and restart the controller then turn the printer

controller PCB. Replace the composite power supply PCB. Turn off and then on the main power. Is the problem corrected? Does the scanning lamp turn on when the Copy Start key is pressed? Or, is it dark

...controller via the Di551 control panel. b. Turn off the sub switch (front switch) of the printer. c. Turn off the main switch (rear switch) of the printer. This procedure assures that the controller ...

...controller via the Di5510 control panel. b. Turn off the sub switch (front switch) of the printer. c. Turn off the main switch (rear switch) of the printer. This procedure assures that the controller ...

...Controller. Turn on the copier and short the jumper wires JP3 and JP4 on the dc controller pcb with a screwdriver. The count ratio indicator on the control panel turns on 'F'. When 'F' is turned on ...

controller lights up but cannot be set on any heat level, it just clicks and flashes up and down. Try to unplug the poligonal motor (laser unit) and turn the machine on.See if turns on. If so you will

Wont turn on Question about Printers & Copiers 1 Answer Power go to treadmill but won't turn on I have a bremshey control treadmill and it won't turn on. There is power going to the control board and ...