Question about Epson Office Equipment & Supplies
Paper output tray is open but message says it is closed Canon PIXMA iP4000. Used compressed air to clean both door position switches but problem remains. Works OK for about 1 in 20 print attempts. I ...
Question about Canon Office Equipment & Supplies
canon copier irc 6800 shows an error e000800-0001 pls help e000800-0001 It is a Fuser error code .Could be a poor connection with the draw connector on fixing feeder unit.Try shimming all three ...
Question about Canon Office Equipment & Supplies
HAVE CANON IR C6800 WITH THE FOLLOWING ERROR CODE... E000001-00ff ERROR CODE... E000001-00ff WHAT DOES THIS MEAN AND HOW TO FIX IT. It is a Fuser error code . Could be a poor connection with the draw ...
jam 1/no cartridge This is the error message I keep getting any clue what it could be It just started doing it out of the blue. I have been having the same problem. I almost gave up on this printer. ...
slow printing Slow printing can be caused by a marginally performing ink cartridge, it is suggested you perform the TAP 43 (and TAP 10) DIAGNOSTIC PRINTER TEST to evaluate the ink cartridges ...
Question about Epson Office Equipment & Supplies
My printer drops and reconnects its USB connection When printing it randomly disconnects and reconnects the USB connection. I have removed and reinstalled the software, rolled back the driver, changed
Question about Samsung Office Equipment & Supplies
I have a CLX-3160FN Printer and it says that my Magenta Toner level is low How can I fix that? Have you tried putting a shim under it to make it higher? Seriously...If the toner is low, you have to ...
Question about Office Equipment & Supplies
hp 2420 I just installed my fuze kit and now it is making a loud clicking noise...it is printing fantastic but sounds like a gear is getting caught...easy fix or buy earplugs? The gears that drive the
...Turning off/on won't do that. You could go into service mode and clear the error (*28* > copier> function > clear > err > ok. Then turn the copier off, then on again and watch ...
...turn off few minutes after turn on You could go into service mode and clear the error (*28* > copier> function > clear > err > ok. Then turn the copier off, then on again and watch it heat up.
24 questions posted
Usually answered in minutes!
1,911 Questions
664 Questions
510 Questions
438 Questions
454 Questions