Question about Proform Exercise & Fitness
is too fat to the right, you'll want to turn the adjustment screw on the right clockwise to tighten and this will bring the belt over to the left. and vica versa for the belt being too far to the left
...belt is to far to the right ,use an allen key, or the allen wrench that should have been supplied, in the right hand side tension bolt and turn it clock wise 1/4 of a turn at a time until the belt ...
...belt should go straight, right now you have it too far to the FRAYED SIDE. Turn the Machine on, have your Hex Wrench in the Bolt and turn it slowly CW and as the belt come back to Center, watch the ...
Question about Nordic Track Exercise & Fitness
...belt with your foot if it shifted too far to one side and is rubbing on the plastic edges.) You likely have a worn motor belt that needs changing or even a pulley on the front roller that is slipping ...
Question about Nordic Track Exercise & Fitness
...belt was so far to the left that the edge began to fray. So, I adjusted the belt towards the right and now it slips forward now and then when it gets up to 3mph or more. Any suggestions? If the ...
...far as it will go toward the belt. It should be lined up parallel to the front roller edge. Now check the green light again by pushing the belt slowly. If it still double flashes, adjust the speed ...
...far as it will go toward the belt. It should be lined up parallel to the front roller edge. Now check the green light again by pushing the belt slowly. If it still double flashes, adjust the speed ...
...belt is too far to the left on the rollers. Thank you. You can adjust the rear roller bolts tighten the left side to make the belt come back to the right. If it will not come back you may have a ...
...closer to the side rail about a quarter turn. Be patient and give it a minute to settle after you adjust it. Repeat until the belt has moved back to center. If it moves too far just back it off a
...far to tighten the bolts back onto the new roller. remove the old roller...install the bolts onto the new roller then tighten back down to the marks you made on the bolts. reverse the process for ...
37 questions posted
Usually answered in minutes!
188 Questions
112 Questions
99 Questions
96 Questions
64 Questions