...tilt them to lift them past the retaining plate. Unhook the lower retracting spring from the front brake shoe to disconnect it. Spread the shoes apart at the bottom to remove the adjusting screw, the ...
...Front End. Remove the front engine splash shield. Refer to Engine Splash Shield Replacement in Body Front End. Remove the upper front mounting bolt from the generator. Raise and support the vehicle. ...
...front-end parts do. It must be put on an Alignment machine. Another area which can tilt a rear wheel is a severely worn spindle or wheel bearing. This would mean the rear strut may be properly in ...
...steps to do this? u need a speacial tool clutch tool removel tool I`ve just found this in the manual: The refrigerant system can remain fully charged during compressor clutch, pulley, or coil ...
...front axle 2007 pontiac van.how do i get the axle out of the hub. To get the axle out of the hub, you have to take the nut off the axle shaft on the outside, and if you're lucky, you can turn the ...
front wipers advance to the park position? YES - Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems NO - Go to Step 3 3 Turn the ignition switch to the RUN position. Turn
Question about GMC Canyon
...front and other places. (options, factory very good) in any case, we can do this, first tell me what engine is there, 8v or 16v (16valves is clearing cast in place on the valve cover) what makes you ...
Question about GMC Canyon
...front axle nut on both sides, the tie rod ends, and ball joint, as much of the brake system and suspension as necessary to get the axles removed. Then, with it up in the air on sturdy ...
...If you have a lot of miles....you have a lot of play in that front end. Go to online site of autozone, oreillys...etc and you may have to register but they have free online step by step
15 questions posted
Usually answered in minutes!
284 Questions
178 Questions
146 Questions
43 Questions
13 Questions