Fisher and Paykel Aquasmart wl80t65c "need help fault 39" Questions

help..... It is showing fault code 130 which is a RPS or Rotor position sensor fault, This is located on the motor stator under the washing machine, Most often this is caused by water leaking past the

help will be gratefully received there is nothing that comes to mind excepted to consult your local washing machine engineer eric Could be drum bearing fault ....Turn by hand is it still grindy if yes

...bad and need to be replaced. If you can get a help of one who knows to make tests with a multimeter you may narrow down the fault. This fault seems to be an interruption of power to the to the

...help here is very appreciated! You need to be more detailed in the description. What is the fault code & is it the same code as before the pump was changed? Why did you change the pump? Was the ...

...need to replace the door interlock or is the circuit board at fault? This was only replaced last year, but the lock wasnt. Its in a mobile home and is barley used. HELP!!! Since the door locks and ...

...fault. Push the latch pin over and trim a small amount of plastic off the door, where the pin rests against. This will allow it to move over slightly further and activate the lock. If the spring in ...

...again. Your help would be very much appreciated. Hi, I need some more information to the brand and model number to assist you. Please get back to me and I will help you the best way possible. ...

f 21 displayed on screen That's a motor fault...most likely the brushes on the motor need replacement. These can be found at your appliance repair stores. Hope this helps...

...need to be verified by a competent technician because it is also possible (though a little less likely) that one of the sensors is sending  back the wrong information to the board. I'm ...

...from hot to cold etc. Check this link. http://www.appliancefactoryparts.com/applianceshvac/help-center/fault-codes/fault-codes-washer.html If you need further assistance please feel free to ...