...Lid Lock Open Circuit Check Harness to Lid Lock and connections at the Motor Control Module and lid lock ends. Primary Fault: Connector to the harness, either end could be at fault. Action: Replace ...
...Lid Lock Open Circuit Check Harness to Lid Lock and connections at the Motor Control Module and lid lock ends. Primary Fault: Connector to the harness. Either end could be at fault. Action: Replace ...
fault code 234 Lid lock failure ,lock mechanism has fault ,conroller faulty , lid not shutting or tongue (on front edge of lid ) that fits into slot on machine is broken.hope this helps.
...F5 error Here is a link to the error codes for your machine. There are several F5 error codes. F5 E4 Lid not opened between cycles F5 E3 Lid unlock fault F5 E2 Lid lock fault F5 E1 Lid switch ...
Question about Fisher and Paykel Washing Machines
...LID LOCK & IT LOOKED A SALTY CORROSIVE TEXTURE ON EACH END OF CONNECTION. ALSO THE TOP LID GROOVE THAT SLOTS INTO THE LID LOCK HAS BEEN GROUND DOWN & IS NOT CONNECTING & PUSHING DOWN TO ENGAGE LID ...
...door failed to lock. Could be misalignment between the lid and the locking mechanism. Try the service mode and see if you can get the door to lock. Otherwise you may need to replace the lock
Question about Whirlpool Washing Machines
Lid Lock Perform the following checks if washer fails to lock (or unlock). 1. Perform Manual: Lid Switch and Manual: Lid Lock tests on page 2. 2. Remove the console to access the machine/motor control
...fault code ''08'' & the lid is locked closed. Turning the power off hasn't released the lid. How do I open the lid & whats the problem. www.electrolux.com.auGo here and type in the model in ...
...start , the temp light bip and flash , any ideas if its a toploader its a lid lock fault 100 percent youll need a new magnet for lid or if doesnt have a magnet, youll need the lock under the top ...
121 questions posted
Usually answered in minutes!
1,514 Questions
200 Questions
87 Questions
45 Questions
22 Questions