...connect to internet, it takes 10 tries and there is an error, it was a used router we bought so does it need to be reset? First, turn-off the DSL-modem (or the cable-modem). Then, turn it on. Check ...
error of of can not complete renewing IP address....Am not able to get to a point where I can change the setting of the IP address.....What is the best way to go about it?? If youconnect to router via
Question about U.S. Robotics Computers & Internet
...connect to it wirelessly by typing that into your browser address bar: Launch a Web browser. In the location or address line of your Web browser, type http://192.168.2.1 to access the Web User ...
Question about Linksys Computers & Internet
connect the router, I was able to login to the SETUP page 192.168.1.1...I have enabled "mac cloning" under SETUP...the subnet mask was 255.255.255.0 and ip address 192.168.1.1. There was another field
...connect to my windstream modem and the internet. when i go to 192.168.0.1 to setup, the page asks for my username and password provided by my isp. when i enter them it goes to the same page and the ...
connect to internet using Ethernet however on Wireless it gives me error as PPPOE authentication failed. Not sure how I can go over here.. I suggest you to hard reset and configure the router settings
...error says cannot find platform service. Make sure service is correctly installled on machine. We have an internet connection and everything is hooked up right. Our wirelsss is disabled on our main ...
...Error: Unable to locate and load drivers." How can I fix it? http://192.168.2.1 to open the routers web interface, use the wizards on the router there is no need to install anything I had the exact ...
connect one end to your computer and the other to any of the 4 ports on the router. (Do not hook it up to the port that is offset, this is for the modem connection) You should get a light on the front
...connect to the Internet again afterwards. You may also need to configure the default gateway settings also. To configure your router device as the default gateway, reboot your PC. When done, open ...
32 questions posted
Usually answered in minutes!
38 Questions
28 Questions
33 Questions
