...engine running. I have changed the ignition coil, changed the spark plug and have also sprayed wd40 on the spark plug cap. It runs better, however still cuts out. It cuts out when I stop at traffic ...
Question about Gilera Gy 150A Motorcycles
brake lights are consuming some of the available current. Lights should actually become slightly brighter when you rev the engine. If it doesn't, then you probably have an issue with the alternator or
...engine by pressing the throttle grip on the right side of the handle bar. Engine is running and in idle position. Press the Clutch lever (left hand) and press the shifter once (left foot) DO NOT ...
...and press the rear brake to stop you moving away ! with a little revs try and set off , if clutch is worn it will slip and not stall the engine ! if this happens then replace the clutch plates
...engine revs. mine is a slower knocking, that slowly speeds up and drops down when i shift up. its nerve wrecking to hear and feel through the pedals, but i have to get to work. any ideas? I have a ...
engine, leaning forward slightly and then dropping the clutch. Be sure to cover the rear brake with your right foot as it will keep the motorcycle from flipping if you give it too much gas. 8 Hold the
Question about Gilera Gy 150A Motorcycles
...engine slow the bike down then when the revs drop down change down to 3rd and so on until you get ot 1st gear. if your coming to a stop quick say at lights or junction then if the bike is in 5th gear ...
...engine or loading the electrical system with brake light, horn or high beam activation. The starter solenoid is down by the battery and if you jump across the big two terminals with a screwdriver ...
...engine shutdown 42. P1501 Jiffy Stand Sensor Low 43. P1502 Jiffy Stand Sensor High 44. P0572 Brake Switch Low 45. P0117 ET Sensor Low 46. P0118 ET Sensor High 47. P0112I AT Voltage Low 48. P0113I AT ...
8 questions posted
Usually answered in minutes!
0 Questions
2 Questions
1 Questions