Question about Hitachi Deskstar Computers & Internet
...set up you can find the jumper location next to the power on a hard drive and the settings for plastic jumper location is usually printed on the top of a hard drive IDE-0 means Pri master IDE-1 means ...
Question about Hitachi Deskstar Computers & Internet
...80 GB/hard drive/9 pin when used as a slave drive? you can find it from this manuel.... ...
how do i get it on slave drive If the drive is the slave drive on a two-drive cable, set the jumpers at A-B and C-D for 16-head logical architecture.
...set my hard disk Hitachi Model: HDP725025glat80 as a Master; and my other hard disk Seagate Barracude 7200.10 as a Slave. Would you mind inform about the correct plug setting? Hitachi Model: ...
Question about Hitachi Deskstar Computers & Internet
...set hds722580vlat20 ata/ide as a slave drive Since it's an IDE hard disk, you'll have to setup disk jumpers, please check the following image: If you want more information please see the installation ...
you for using FixYa for your problem These are to tell the unit if it is to use Master, Slave or CS settings Please rate our solutions and if you still have problems please call back for more ideas to
...hard drive. I think it has crashed on me as it is not showing up in my BIOS anymore. I have checked the cables to ensure that they are secure, I have cleared my CMOS by removing pins on MB. Is there ...
HOW CAN I SET IT TO SATA 1.5 ? mY MOTHERBOARD COES NOT SUPPORT HDD WITH SATA 3.0 ! It should be backwards compatable but it might be that you have to switch a jumper. instructions for this should have
Question about Hitachi Deskstar Computers & Internet
...hard drive) The BIOS is AMI. Under ADVANCED SETUP: The options listed for 1st,2nd ,3rd Boot device include: IDE-0 means Pri master ? IDE-1 means Pri slave ? IDE-2 means Sec master ? IDE-3 means Sec ...
...either Master or Slave. If there is a CD drive on this cable too then the drives on this data cable then the jumpers on each drive must be set differently, they cannot be set the same jumper
10 questions posted
Usually answered in minutes!
18 Questions
5 Questions