Hitachi Deskstar 7K250 80GB (hds722580vlat20) 80 GB Hard Drive "jumper settings" Questions

...settings for plastic jumper location is usually printed on the top of a hard drive IDE-0 means Pri master IDE-1 means Pri slave IDE-2 means Sec master IDE-3 means Sec slave single or master ::::: ...

jumper settings/Deskstar 80 GB/hard drive/9 pin when used as a slave drive? you can find it from this manuel.... ...

how do i get it on slave drive If the drive is the slave drive on a two-drive cable, set the jumpers at A-B and C-D for 16-head logical architecture.

how do i set hds722580vlat20 ata/ide as a slave drive Since it's an IDE hard disk, you'll have to setup disk jumpers, please check the following image: If you want more information please see the ...

what are the jumpers for? Can you fit a 320 gb in a HP d530cmt? Hello Thank you for using FixYa for your problem These are to tell the unit if it is to use Master, Slave or CS settings Please rate our

...HDD WITH SATA 3.0 ! It should be backwards compatable but it might be that you have to switch a jumper. instructions for this should have come with the hardrive itself but if not check this out ...

what are the 2 pins in the back for? master slave configurations? If so what jumper setting makes it a slave? During the boot process you will see on the screen to press a certain key to enter setup ...

...verified working condition by trying another drive have you verified voltage to the drive is the jumper setting correct you can try hitachis drive fitness tool heres the link ...

...jumper contactor, nevermind just use what ever conductor cable to roll between the two pin and make sure the pin is connected that all. YBC (/\) Hello! Here are your jumper settings: Hope this

...also, if one is set to single drive it will likely bypass the slave drive. Here is the link that will teach you on how set your jumper settings easily from IDE to SATA maxtor hard disk ...