Behringer EURORACK UB2442FX PRO Mixer "amp clipping input" Questions

Ad

you need to keep the viltage input to the amp at 1 volt peak to peak or less, or you run the risk of clipping.  You should use shielded cable, as you may also pick up other noise along that cable

Ad

...of my SA220 is on continuously even with nothing plugged in the XLR or 1/4 inch inputs. Not getting amplification when inputs are used. Why? Why is channel 1 clip LED on continuously and not getting ...

Ad

Question about QSC Music

1 Answer

amp 5050 rmx stay in clip mode Disconnect speakers. With NO input, if clip light remains on, take in for repair as there is an internal failure. If reducing the gain and loudness keeps the clip off, ...

input on it at all why's this? Using a multimeter VERIFY the amp is not putting out a DC bias into your speakers. If it is it may cause damage to the speakers. I would not TOLERATE a bias in excess of

AMP and that it is the original unit. The clip lights monitor levels at several points. If you cranked the EQ's for maximum, say bass, that MAY cause them to illuminate. As a test, set all EQ's at mid

...is good advice as it protects your amp and your speakers. The clipping is not caused by the amp but by the amount and quality of signal being input. Check earlier in your signal chain for the

...same receptacle. All audio lines should use balanced interconnects where possible using XLR or TRS cables. Cross connect another amps preamp into the effect loop input to check the power amp

Question about Behringer Music

1 Answer

...clipping. You need to almost scream to get any sound with a mic. if I need to use a pre-amp, how would I connect it? It's the europower pmp3000 Thiis amp has plenty of gain for mics. Make sure your ...

Question about Behringer Music

1 Answer

...on even when no input and when bass is plugged in input low volume and distortion at speaker output One half of the power amp has failed. You can damage the speaker... do NOT use this until

SWR WorkingPro 400 watt head - no sound, Preamp Clip red LED is continually lit, Limiter green LED continually lit - fuse is perfect. It worked for a few minutes, then just stopped. Since the PA clip ...

Not finding what you are looking for?
Behringer EURORACK UB2442FX PRO Mixer Logo

26 questions posted

Ask a Question

Usually answered in minutes!

Top Behringer Music Experts

Cindy Wells

Level 3 Expert

6688 Answers

Brad Brown

Level 3 Expert

19187 Answers

john h

Level 3 Expert

29494 Answers

Are you a Behringer Music Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...