Jensen JX1200 Car Subwoofer "subs stop working new amp" Questions

new sub stopped working? the problem sounds like your new sub is drawing to much power and your amp can not handle it. bridging the amp is a good way to get the full power out of your amp. But it isnt

...subs stopped working, their is power to amp, lights are on, and power going to subs, then now and again they start working, so i checked all wires, they ared ok, then i banged the sub box and they ...

...working fine then just stopped. On inspection the protect light on the amp was on and the sub cone was rock hard. Then i took the sub out of the box and there was plenty of smoke. Now i realise that ...

...subs on the 6x9 stop working only bass. i have pioneer 6x9 and 5.25 with alpine flex amp not sure watts subs 2 p2 rockford fosgate with 1200 watt power acoustic amp You probably have too much hooked ...

Subs stopped working & protect light on the amp is red... Ok first questions were is the serial number located on these subs? Ok well I bought 2 VOLFENHAG 2000 W SUBS and VOLFENHAG ZX 7180 2 CHANNEL ...

new one and the same problem occurs. the amp maybe going into protect mode. it may be seeing a fault internal and causing this. so i would have to say check all the wiring over and if that is okay you

working my stereo is the cdx-gt50w I also know it's not something lame like the remote turn on cuz the Amp and sub r powered up they wil play if I hook it to rear out and no I don't wanna just hook it

working when the volume is turned up. Just bought new amp. Everything is hooked up correctly so whats my problem? you might nee a new speaker sounds like your amp is going into protect mode your voice

...may have blown out my subs?? Bad wire somewhere, bad amp, bad cap or what. PLease help!! rewire the whole system with new wires,you could have a bad ground or wire try it first if that dont work ...

...subs and one for the mains its probably not the power or ground going to them since both are not shutting down but check where the power splits to each amp. start at the amp that isn't working unhook ...