Question about Volfenhag Car Audio & Video
...new one], contact its positive side to one terminal of the speaker, and its negative to other terminal win a piece of wire. Just touch once. Look the movement of the cone paper. For one side ...
new speaker surround to the outer portion of the speaker cone, either on the underside or inside, as it was with the prior surround. Make sure it's centered, applying just enough glue with a brush
...to construct a new surround. A product called "shoe goo" makes a good permanent bond. It's a super strong rubber cement and will hold up under the stresses of the moving speaker cone. Hope this
...new speakers have metal frames.. Well both went tinny and fuzzy within 15 minutes.. Did they need to be insulated from the metal rear deck or did they need to be dropped in from the top? I'm not sure ...
new surrounds to replace your bad one. It's not easy, but can be done. It takes some special glues and some patience. I've done them, and it's not too tough. A rip in the cone is easier, because while
...cone should move in or out depnding on polarity pos to pos forward excursion if voice coil is not cooked or seized ...if speaker dead no movement wait 10 years till you can appreciate moderate bass ...
...cone of the woofer in gently with your hand. the woofer should move a little more than an inch, without any resistance, before bottoming out. if there feels to be any resistance, like a rubbing or ...
...cone. Does it move at all(Freely)? If no then the lacquer on the voice coil has swollen from heat and bound the woofer. You would have to either have it replaced(Serviced) or buy a new woofer.If the ...
Question about Rockford Fosgate Car Audio & Video
the woofer cone is stuck. it will not move at all. can it be fixed? you have burned the coil and it is froze cheaper to buy new
3 questions posted
Usually answered in minutes!
481 Questions
126 Questions
44 Questions
31 Questions
26 Questions