Jensen VM9510 Car DVD Player "12" Questions

error 12 and error 17 only for dvds iiMesisage Cause Action ERROR-11, 12, 17, 30 Dirty disc Clean disc. ERROR-11, 12, 17, 30 Scratched disc Replace disc. ERROR-10, 11, 12, 15, 17, 30, A0 Electrical or

Red light comes on but the unit wount turn on The red light is associated with the memory (constant 12 volt power). You also need switched 12 volt power (power with key turned to accessory)for the ...

...based on my previous experience with the Alpine Mobile Multimedia Station, 1 wire needs to see 12 volts ie. brake light wire, the other needs to see ground ie. parking brake. You can hook up the ...

what does the yellow and black wire that says battery go to? yellow goes to a 12 volt power source that never goes off no matter what position you have the key in. Black wire is ground and that can be

on the cd mode When I play a cd, there is only sound on my front door speakers. I have 2 amps and a 12" sub hooked to the radio and the radio mode works fine but when i play it in cd mode, the sub and

are 4 wires that must be connected other than the speaker/amp connections. These are: Red - to the +12 supply (normally an ACC/IGN B+12 in the car); Yellow - to the +12 supply (normally an always on B

...and the switch that opens and closes depending on the position of the parking brake (set or not). 12 volts is always present from the battery to the top of the lamp. It passes thru the filament to ...

/service.us.panasonic.com/OPERMANPDF/CQVAD7300U.PDF Page 74 has wiring diagram. Yellow wire goes to 12 volts always on and red wire goes to 12 volts that turns off when you turn the car off

...4 Grey Right Front Positive 5 Blue/White Amplifier Remote 6 Blue Antenna Remote 7 Red Accessory 12 Volts 8 Black Ground 9 White/Black Left Front Negative 10 Green/Black Left Rear Negative 11 ...

...installation can i ground the brake in wire to get the dvd screen working Either that or it gets + 12 V DC, you need to connect a low value 1000 ohm resistor in series, and use that to check, if