...lamp,cover` and I cannot do anything with the projector. When you open the lamp cover for replacement of lamp there is a switch in the projector is OFF If lamp cover not fix proper after replacement ...
lamp/cover light flashes Did you replaced lamp in projector? if yes, please make sure lamp cover is fixed properly on its position. There is safety switch under lamp cover that needs to be pressed to ...
Question about Sony Office Equipment & Supplies
lamp/cover blink. Power on, it Sony VPL-CX61 lamp/cover blink. Power on, it works. After about 10-20 seconds, it does not work, and lamp/cover led blink. hi, your projectors lamp cover may be open. or
Question about Sony Office Equipment & Supplies
Lamp /Cover LED and Power ON/Standby LED flashes. Sony VPL-EX1 turns on for a few minutes and then the Lamp /Cover LED and Power ON/Standby LED flashes. I have cleaned the air filter and also reseated
...lamp cover fixing screw with the screwdriver supplied (through the small hole in the side of the lamp cover) with the new lamp or a + head screwdriver. Then slide the lamp cover straight forward and ...
...lamp cover is not properly closed. Disconnect the mains power and carefully open the lamp cover, reseat the lamp and close the lamp cover taking care not to force it. A fault of this type would be ...
Question about Sony Office Equipment & Supplies
Lamp cover light flashes even with new lamp The projector will not turn on as the lamp/cover light is flashing. I have replaced the bulb and the lamp cover and air filter cover are both closed ...
...lamp/cover. Hi, Either lamp is dead/ broken in projector or lamp cover is not fixed properly (its located at bottom side) Please check lamp and replace it if its broken and make sure lamp cover is ...
Question about Sony Office Equipment & Supplies
...lamp cover light is blinking then projectoe gose off hi, There is two possibilty for this problem one is the lamp cover is not properly placed and the second one is the lamp has reached end of its ...
...lamp cover by pushing two grooves lightly with the flathead screwdriver. You can see the lamp cover on the top of the projector. ( left side of the lens) 2.Loosen the two screws securing the lamp ...
36 questions posted
Usually answered in minutes!
94 Questions
59 Questions
55 Questions
35 Questions
28 Questions