...led blinks four times repeatingly. Hi, White line across the screen indicates that tv got vertical deflection failure problem that may be due to vertical output chip failure. If that kind of problem ...
Question about Quasar Televison & Video
Vertical output (la7838) and a DIODE (23118095). Quasar model # sx3164hk, Serial AS22900119. Sounds to me like something else is causing those parts to fail. It should be under warranty but depends on
...centre of the screen. The TV then shuts down leaving the on/off LED indicator light flashing red. check the resistors and capacitors in vertical section of the television..or change the vertical
...LED Blinks 4 times Light Blinks 4 times, screen will not come on. Which part needs replacing to correct this error code? Four blinks - No vertical Deflection (V STOP), Screen goes to a single ...
Question about Sony Televison & Video
...led make a pause and keep blinking 4 times, what that could be? Four blinks - No vertical Deflection (V STOP), Screen goes to a single horizontal line then the video signal muted. Check IC1509, ...
only a vertical white line is flashing in centre of the screen. sound is ok. my onida ky thunder giving fault led blinking after plugin and after 5 second goes to stopped mode Your TV IC has gone bad
...vertical lines on my teak lcd/led television my tv has vertical lines across the whole screen If you wish to get some details; check the site linked here. Pull up older posts. ...
Question about Sony Televison & Video
...led, what that means? Four blinks - No vertical Deflection (V STOP), Screen goes to a single horizontal line then the video signal muted. Check IC1509, Q1505. This is the fault. Check all ...
Question about Emerson Televison & Video
...dresser to next. worked fine until I moved it. now black and grey screen with black horizontal and white vertical lines The connections are not fixed properly. Tighten or replace the lines
Question about Memorex Televison & Video
...By now you've probably replace this with a Flat Screen LCD, LED or Plasma unit. But the answer to your original problem is a loss of vertical drive. Possibly just a bad solder joint @ the vertical
90 questions posted
Usually answered in minutes!
1,430 Questions
874 Questions
716 Questions
647 Questions
601 Questions