Sylvania 6842PE 42 in. HD-Ready Plasma Television "set panel voltage" Questions

panel itself. Each panel is independant so no two sets will be alike. In most cases you can swing the vscan up or down by 10 volts to see what happens. Anymore than that can cause the set to shut down

...panel inside the set, find the VS test point and the VS adjustment potentiometer. adjust the voltage down at least 10 volts, if your not an experienced person in electronics, get a person that is, ...

Blank screen The unit will turn on (green light) but the screen is blank. Is this a problem with settings on the unit or more serious? Thanks. you need to check the screen voltages inside the unit is ...

voltage on tuner all ok.Voltages on mainboard ok.Would like to get into service mode to check settings.Or do we have a eeprom problem.? You have antenna connected? Is TV set for broadcast or cable or

...set on With a digital voltage meter find the test point on the power supply that says VS. If you cannot find it, you can still measure it at the connector. It will say VS in a few different places. ...

...setting incorrect voltages can damage your screen and the voltage controls are located inside the tv. The set holds potentially lethal voltages for several hours after its turned off and

...set for 24 hours, if haze doesn't come back the unit is considered repaired. If haze returns, then the problem is with the panel itself and wouldn't be worth it to replace because it will cost more ...

...set cost when new. The panel connects to the boards that drive it with either a multi-pin conventional plug or a RIBBON CABLE. The worst case is the problem is a ribbon cable etc. bad or damaged ...

...ok. Note: On your set when replacing the SMPS the tech Must adjust the SMPS voltages to the Panel Voltages. There is a sticker on the Panel that list the voltages the tech must adjust on the

...voltage details will be on the silk label at the panel. Just visit this site. It has details about voltage settings to Panasonic Plasma TVs. Pull up older posts there. Check the site with patience. ...