Samsung DLP HL-P5663W 56" TV "lamp temp" Questions

...lamp temp board wire is not unplugged then you definitely have a ballast problem. Those are the only components that can cause the lamp to fire. The lamp temp board is a little board on top of the ...

...fan inside the set is not operating properly. 3. If Lamp and Standby/Temp blinking --> The lamp cover on the rear of the set is not installed properly. I hope that solve your problem.

...and the Standby/Temp blinks once. The LED then starts blinking continuously until it stops and the SB/TEMP goes solid. Any ideas? It might be the lamp unit which is LED and not a usual type of

...temp and lamp lights blinking... won't turn My (?) 56" Samsung DLP TV won't turn n. The three lights on the front panel are blinking (time, temp, lamp) What is wrong and how do I get in home service? ...

...Lamp, standby/Temp).I would advice you to open the back cover of your unit, fixed the lamp door safety switch with the tape to make it in closed position( if it is on open position the unit will not ...

screen went black no picture i changed the blub and housing i get the message lamp and stand by temp Check lamp door, check thermal sensor above lamp.  Should read zero ohms.

...temp light on in front but can not be hot as lamp never comes on. Iss there a way to reset the temp light. thanks Bill hi if your tv starts for a few seconds and restart again and go back to stand by ...

...Lamp Light, Red Timer Light, and Red Standby/Temp Light) blink. Manual suggested this may be a bad lamp so I replaced. This has not resolved the issue. Same exact problem exists. New lamp has never ...

lamp and stand by temp flash on the power button. I removed the back lamp cover door and sprayed it with a dust can, but did not make a difference. 3 years its about that time to change the lamp. Call

...Lamp ,Temp or fan). If Lamp, chech the lamp. If Temp, its mean hight temperature detected . check fan on engine, is it rotate smoothly or not, change that fan if necessary. If Fan, its mean fan not ...