...remove burner shield and clean the burner inside the oven. make sure all holes in the oven bottom are not covered with anything (i.e. foil) adjust ignitor position (move it slightly closer to
Question about Whirlpool Kitchen Ranges
potato exploded and pieces got in the bottom of unit there are 2 screws holing the bottom inside base of the oven, can i take these off and remove the base bottom cover? to clean the pieces out. Sure
Question about KitchenAid Kitchen Ranges
bottom oven burner is not burning blue but yollow the control valve has flow through that port if the valve is partly stuck would it make this happen check that the bake ignitor is drawing min 3 amps.
...bottom of the oven blew put a big hole in the element. I replaced the element and now the oven will not heat up. Could it be the thermostat or a fuse if it is a fuse where would it be located. Thanks ...
...holes in the bottom floor (so the screws can not all in there) and remove the 2 screws. Then slide the bracket off the end of the burner tube. Then look at the bottom front and note which alignment ...
holes at the bottom put the overlay on the new eoc and put the top of the bracket in first then push the bottom in making sure the holes in the bottom line up with the holes on the cotrol panael go to
Question about Stoves Kitchen Ranges
...bottom up from the back, but the front edge will not disengage from whatever it is hooked on. No matter how I push, pull, pry or yank (note I started with gentle pushing and pulling and progressed to ...
...bottom of the oven. I'm guessing it somehow went through a right side vent. It was extinguished and I removed the bottom panel. I discovered a five inch long by 1/2 inch wide stainless steel handle ...
...oven elements (top &bottom) don't kick in you will need electrical meter. Take unit out of hole remove back plate( unplug or turn breaker off first). Turn power back on set temp for bake check leads ...
bottom oven element, there are two holes on either side of the oven where the element is put in, on one side i have 2 wires on the other just the hole, i dont know if there is meant to be wires coming
2 questions posted
Usually answered in minutes!
35 Questions