Roland KC550 Amp Keyboard "noises hiss" Questions

hiss as soon as i turned on the device to do a recording, found a high level of hiss. If trim controls or gains are set near maximum, HISS is normal as electronics generates a thermal type noise. If ...

6 mnths old Alto L8 Mixing desk developed hiss on channel 1 only. the desk was fine for about 6 months & is used about 3 times a week just for vocal p.a.. Now channel 1 on the desk is generating a

my swr workiongpro 15 suddenly has a very noticable hiss even when the amp is muted, and when I play the high end is more prominent than it was before. If you are having the treble/high turned up ...

HOW DO YOU TURN DOWN THE HISSING NOISE You can cut the treble gain some BUT most importantly is to send adequate signal to this speaker so volume level does not have to be set high when sending LINE ...

Hiss in new fender frontman 65R. Can't seem to dial it out in either input. A certain amount of "hiss" is present in electronic amps due to the statistical noise in electronics. The hiss should be ...

HISS from Numark DM1200 mixer. Not present in speakers (self powered) when mixer off. Using XLR cables with telescoping ground lifts on each line. Monster 3500 power filter. Ideas? All interconnected ...

6505 +112 has a bad hiss with nothing plugd in Some hiss at high gain settings is normal. If you get objectionable hiss at 1 o'clock settings of gain, that is too high. Electronics has noise that ...

How can I reduce white noise / hissing I'm getting over the mic on a Behringer Xenyx 1204 USB setup? I have a just bought a Behringer Xenyx 1204USB mixer, a couple of Behringer C-1 mics, and 3m Stag ...

my new mg50fx has a ton of hiss when i turn it on. anything i can do? Make sure the master volume is turned up and the inout gain is down some. All of the electronic devices suffer from the ...

Why does my UREI 1620LE hiss on phono channels and aux 4 channel ? All input and earth connections disconnected produces a loud hissing noise on all channels apart from aux channels 1 to 3 are you ...