Question about Marantz Audio Players & Recorders
...I need to replace the lamp in Marantz 4060 Quadradial Amp but I'm not sure are those available fuse lamps good for the amp or they are for receivers. It should be 8V and 0.25A, it looks like a fuse ...
Question about Harman Kardon Audio Players & Recorders
...bulb for the radio station display? I'm assuming this is an LCD back lit display. To replace the lamps (usualy more than one) you will need to unsolder all the contacts on the LCD display. Usualy ...
...reciever? I presume you have taken the unit apart? Most receivers of this vintage had replaceable lamps, the trick was getting to them! Some were held in place by glue, some were in rubber
led screen wont light up. Hi, my led screen wont light. Do I need to replace the 14v lamp? How much to repair do you think? Cheers. Does it works besides the lamp? If so then this can be cheaply ...
Replacement display lamps I require replacement display lamps for my Harman Kardon 630 Twin Power Tuner Amplifier (1973-1975. Can you tell me where I can source them have you tried PartStore.com?
my amp does not have lights on dial hi, check the lamp behind the dial inside you amplifier. may be it fused. its a small 12v bulb. also check the voltage at its pins is it ok or not. normally the ...
Question about Cambridge Audio Audio Players & Recorders
My Cambridge A540A just stopped last evening and the protection lamp is flashing and I have lost the manual. ng tried mains of and on again but protection lamp flashing but only when I try to engage ...
Panel lamps for Mcintosh MC352 Hi, Can anyone tell me the type and value of the panel lamps for the Mac MC352 ? I'd like to get the replacement bulbs before the amp is disassembled. Thanks in advance.
...a soldering iron. Most generally are 12 volt, meter it first if you have a multimeter, You can buy lamps to suit from Farnell electronics in most countries of the world. If you have any trouble ...
...them anywhere. Any suggestions where I should be looking for these? Unit probably uses fuse type lamps, either 8 or 12 volt filament. Remove one of the lamps and look for voltage rating on end
17 questions posted
Usually answered in minutes!