...to hold it down for a few seconds if the cook top has automatic flame detection. A bi metal strip (or some other form of thermostat) near the burner will need to heat up before the burner can lock
...metal piece that the spark comes off from) is clean and the holes in the burner are clean, use a pin or paper clip to clean out the burner holes and not a tooth pick as these can break off and make ...
...just give them a little nudge and you have to make sure area is perfectly clean for spark to take effect, spark will go for cleanest area on metal. so ensure area is clean and check burner ...
...knobs, take off the plastic cover. unscrew the four metal screws holding the the display panel on. remove the 5 silver screws across the top inside of the plastic cover front and the 2 black ones on ...
...knobs wouldn't turn at all. Then the next day they would turn again, but didn't control the gas flow. Even in the off position the gas was on, on those 3 burners. The only way to turn of the gas was ...
...metal piece that the spark comes off from ) is clean and the holes in the burner are clean, use a pin or paper clip to clean out the burner holes and NOT a tooth pick as these can break off and make ...
metal point or "nib" located on underside of burner cap after the burner mounting screws have been tightened. (Not all burners having mounting screws). When the burner control knob is set to the "LITE
...burner was still lit. There was an odd burning type of smell. but we cou;dn't really detect any gas smell. This happened twice. Has this ever happened before? I would say that pop was one of you ...
...When wife cleaned cootop one of the burner wire hit metal and she saw sparks. After that there was no spark to igniters YOU NEED NEW SPARK SWITCHES. CHECK HOW TO REPLACE THEM HERE. HOPE IT WILL
32 questions posted
Usually answered in minutes!
6 Questions
1 Questions
1 Questions